10.0.0.1 Login Admin

10.0.0.1 IP Address

To access the admin panel type 10.0.0.1 in the address bar of your web browser or click on the button below:

Login  Admin

10.0.0.1 – 10.0.0.0.1 is a Login Admin. The common default IP address used bу many routers. Therefore, tо configure wireless router ѕеttings on our сomputer ѕystem, there is need to set thеm using the same network. Most household broadband routers have the IP address 10.0.0.1 including many Belkin and SMC models. It is built as a default access point by the creator one but it can be altered. We can Proceed tо thе setup interface tо get оur network wоrking Correctly.

How to Login to 10.0.0.1?

If you want to open the admin panel of your router, you just put http://10.0.0.1 in the address bar of your browser. It will require login credentials your username and password if you put write address. Now when you log in it you can change many options here. Occasionally your router is detached from the internet. In this situation, your browser gives an error message that the webpage is not available.

Restrictions of Using 10.0.0.1

If you are using 10.0.0.1, then you cannot attach another router that is exterior from your home network. It happens due to the usage of a private IPv4 network address. If you want to use two routers on your home network at a parallel time then it is only possible if both have different addresses, To know about the address of the local router you can look up the default gateway on a device which is connected to it.

Changing 10.0.0.1

With the admin panel, you can change the default local address setting and also your router’s setting. You can change the preferences of your IP address either 192.168.100.1 or 192.168.2.1 in the LAN section which is present in the Network option when you are signed in it.

Reaching 10.0.0.1

For accessing the modem’s admin panel, simply write http://10.0.0.1 in the browser’s address bar. If you do not remember your password or you are confused regarding your password then you can reset your modem to its factory settings by pressing the reset button

Leave a Reply

Your email address will not be published.

Scroll to top